Görüyorum ki adblocker kullanıyorsun
Press "Enter" to skip to content

What is the Rj45 tip, how to crash?

RJ45 (Registered Jack) is a connector of connections manufactured by international standards (i.e. wherever you are in the world).

Rj45 connector

It has 8 metal pins on it. It is used by crashing into the end of the so-called cat5 or cat6 cables. I say crashbecause there are scissors specifically used for this job. Thanks to these scissors, the metal pins at the end of the rj45 connector are placed and crashed into the wires inside the ethernet cable. I’ll tell you more in a minute:)

There are many different rj45 connectors in the market with different brands and quality. All of these connectors are standard for cables called CAT5 and CAT6.

A certain standard is used when crashing Rj45 connectors into the cable. So you can’t randomly sequence colors like that. Two standards are used for this job. T-568A and T-568B.

T-568B standard is generally used in our country. The ranking is as follows:

  1. Orange white
  2. Orange
  3. Green white
  4. Blue
  5. Blue and White
  6. Green
  7. Brown white
  8. Brown

The T-568A ranking is as follows:

  1. Green white
  2. Green
  3. Orange white
  4. Blue
  5. Blue and White
  6. Orange
  7. Brown white
  8. Brown

Since t-568B standard is generally used in our country, you do not need to learn and apply the other standard. But know how 🙂

How to Bang Rj45 Tip ?

First of all, we adjust the cables according to the standard that we will use carefully, respectively. Then we hold the nail part of the Rj45 connector downwards and push the ethernet cable into the rj45 connector.

Make sure that each wire on the Ethernet cable is equivalent to a pine on the rj45 connector.

Attention! Attention!

After sitting in each wire, we check whether the pins of the rj45 connector come into contact with the cables. If everything is in place and true, we put the connector in the rj45 slot of the rj45 connector of the rj45 connector. Continue the ethernet cable on the one hand, and the cables will be fully in place.

After the compression process is over, our rj45 tip is ready 🙂 Good luck with that.

Be First to Comment

    Leave a Reply